LOOKSMETER · GUIDE
Facial index: is your face long, average or short?
The facial index is face height divided by face width, the oldest way to classify a face as long, medium or broad. Classical adults centre near 87 on the morphological scale. Our photo ruler starts higher on the face, so the median length-to-width ratio across 1,404 measured faces is 1.21. Here is how both are measured, what the bands mean and how to read your own. Measure your face ratios free →
What the facial index is
The facial index is the oldest answer to the question of whether a face is long or short. It is face height divided by face width, scaled to 100. The morphological version used in anthropometry takes height from nasion, the notch between the eyes at the top of the nose, down to gnathion at the bottom of the chin. Width runs between the two zygion points at the widest part of the cheekbones. A value of 100 would mean the face is as tall between those points as it is wide.
The index strips away size. A large face and a small face with the same shape have the same index. That is what makes it useful for comparing people, populations and the same person over time. It is also why it survived from nineteenth-century anthropology into modern orthodontics and surgical planning.
How it is measured
With spreading calipers on a person: nasion to gnathion for height, zygion to zygion for width. On a photo the same two distances are taken in pixels, which is fine because the ratio cancels the scale. The difficulty is the landmarks. Nasion is easy to feel and hard to see, which is why photo-based systems often start the height measurement somewhere else.
Our reports measure face length from the top of the tracked face area, which sits at or just under the hairline, down to the chin. It divides that by cheekbone width. That is a longer ruler than nasion-to-chin by most of the forehead, so the numbers are higher: across 1,363 front-facing faces the median is 1.21 with the middle half between 1.17 and 1.26. Read your number against that table. Do not divide it by the classical 87.
A second width-based ratio often reported alongside it is fWHR, cheekbone width divided by the height from mid-brow to the upper lip. It describes the middle of the face rather than the whole and moves in the opposite direction: a long face has a high facial index and a low fWHR.
Classical categories and measured ranges
The five-band scale from Martin and Saller is the one most studies still use. European-ancestry samples in the Farkas series centre on the medium band, with men averaging an index near 87 and women near 86. Sex barely moves the index because men are larger in both height and width. Population moves it a lot: South Asian and East African samples often centre in the long bands, East Asian samples in the medium and broad bands, Central European samples in the medium band.
In our own photo-based ruler the same spread appears as a length-to-width ratio between roughly 1.11 and 1.32 for the middle 90% of faces. The table below gives both that ratio and fWHR from the same 1,404 faces.
| Ratio | 5th | 25th | Median | 75th | 95th |
|---|---|---|---|---|---|
| Face length to width (tracked top to chin) | 1.11 | 1.17 | 1.21 | 1.26 | 1.32 |
| fWHR (cheekbone width to mid-brow to lip height) | 1.44 | 1.54 | 1.63 | 1.73 | 1.88 |
Below 80: hypereuryprosopic
Very broad. A wide, short face with prominent cheekbones from the front.
80 to 84.9: euryprosopic
Broad. Common in many East Asian and Central Asian samples.
85 to 89.9: mesoprosopic
Medium. The band most European-ancestry adults fall in, men and women alike.
90 to 94.9: leptoprosopic
Long. A narrow face, often with a long midface and nose.
95 and above: hyperleptoprosopic
Very long. Uncommon in most populations.
What changes the index
Bone sets the index by the late teens and does not move afterward. Soft tissue does. Weight gain sits over the cheekbones and along the jaw, widening the measured face and lowering the index by a point or two at the extremes. Weight loss does the opposite and is the usual reason a face looks longer after a diet. Age thins the midface fat pads and lengthens the lower face slightly as lip and chin tissues descend, so the index tends to drift upward across decades.
Hair changes the photo version far more than the classical one. Because a tracked measurement starts at the top of the detected face, a high or receding hairline lengthens the face and a fringe shortens it. Hair over the temples hides the widest points and narrows the width. Pull it back before measuring.
Camera distance and height change the index by more than weight does. A lens inside arm's length enlarges the centre of the face relative to the edges, which narrows the apparent cheekbones and raises the index. A camera below eye level stretches the lower face. A camera above compresses it. Measure at eye level from 1.5 metres or more, every time, if two readings are going to be compared.
How to read your own
If you measure from nasion to chin with a ruler and a mirror, use the classical bands. If you measure from a photo, use the percentile table and compare against other faces measured the same way. Either way the number is a description of shape, not a grade. Long faces and broad faces both appear in every list of highly rated faces ever compiled.
What the index is good for is explaining other numbers. A long face usually has a low fWHR, a longer middle section and a narrower-looking nose from the front. A broad face usually has a high fWHR, wider-set eyes in absolute terms and a shorter lower third. Hairstyles, beards and glasses that balance each pattern are well documented, which is where the index earns its keep.
Frequently asked
What is the facial index?
Face height divided by face width, multiplied by 100. The classical version, the morphological facial index, uses the height from nasion between the eyes down to the chin and the width between the cheekbones. An index near 85 to 90 is average. Lower is a broad, short face. Higher is a long, narrow face. It is one of the oldest measurements in physical anthropology and still the standard way to classify face length.
What are the facial index categories?
The Martin and Saller scale, still used in anthropometry, has five bands. Hypereuryprosopic, very broad, below 80. Euryprosopic, broad, 80 to 84.9. Mesoprosopic, medium, 85 to 89.9. Leptoprosopic, long, 90 to 94.9. Hyperleptoprosopic, very long, 95 and above. Most European-ancestry adults fall in the medium and long bands. Many East Asian samples centre on the medium and broad bands.
What is the average facial index for men and women?
Using the Farkas norms, young adult men average a nasion-to-chin height near 121 mm and a cheekbone width near 139 mm, giving an index around 87. Women average near 112 mm and 130 mm, giving an index around 86. Both sit in the medium band. Men's faces are larger in both dimensions by roughly the same proportion, so the index itself barely differs by sex.
Why is LooksMeter's face length to width ratio not the same number?
Because a tracked photo measures face length from the top of the detected face area rather than from nasion, which adds most of the forehead. That is why our median length-to-width ratio is 1.21 across 1,363 faces rather than 0.87. The two rulers start at different points. Compare your number with our table, not with the classical scale, unless you measure from nasion yourself.
Does the facial index change with age or weight?
The bone is fixed from the late teens. Weight changes the soft-tissue width across the cheeks, so weight gain lowers the index and weight loss raises it, usually by a point or two. Age lengthens the lower face slightly as the lip and chin tissues descend and can narrow the midface as fat pads shrink, which nudges the index upward by a similar amount. Camera distance moves it more than either.
Email me the cheat-sheet
Get the cheat-sheet + a first-time member perk
Get our facial harmony & styling reference sheet emailed to you.
Explore more
Keep reading
Ricketts E-line
The lip position test on a side profile, with norms by population
Forward growth
What a recessed maxilla means, measured with the facial convexity and nasomaxillary angles from a side profile.
Recessed chin
How to measure chin recession from the side: Ricketts E-line, zero-meridian and chin projection with adult ranges by sex.
This page is general information about facial aesthetics terminology, not medical or cosmetic advice. Scores from our tools are calibrated reads of one photo that describe presentation, never your worth.