LOOKSMETER · GUIDE
Facial thirds, measured
The equal-thirds rule is a drawing convention that real faces do not follow and that a tracked photo cannot even apply, because the ruler starts at the hairline rather than at an artist's mark. Here is what each band measures, why our vertical sections are reported against 1,404 measured faces instead of 33% and what a long or short section is usually made of.
The classical thirds and where they come from
The division of the face into three equal horizontal bands is a drawing canon that dates to Renaissance proportion studies. It is a way to construct a plausible face on paper: hairline to brow, brow to nose base, nose base to chin, each a third of the total height.
It works as a construction aid because it is simple. It fails as a measurement of real people because real faces vary, the hairline is not a fixed landmark and the canon was never derived from measuring a population. Anthropometric work since then consistently finds that lower faces run a little longer than middle faces and that upper faces depend on hair as much as bone.
Upper third
Hairline to the brow line. The band most changed by hairstyle, fringe, hairline recession and age. Also the band where every measurement system disagrees about where to put the top mark.
Middle third
Brow line to the base of the nose. Carries the eyes, the cheekbones and the nose length. The most stable of the three because both landmarks are bone-anchored.
Lower third
Base of the nose to the bottom of the chin. Carries the philtrum, the lips and the chin. Commonly subdivided again: the upper lip to the mouth line is about a third of it, the mouth line to the chin about two thirds.
Why a tracked photo cannot use the 33% rule
When a face is measured from a photo by landmark tracking, the top of the face is the top of the detected face area, which sits at or just under the hairline. That is a different point from the trichion a classical artist would mark. It moves with hair. So the first band in a tracked measurement is shorter than a textbook upper third by construction. The other two bands are correspondingly larger as shares of the total.
This is why LooksMeter reports vertical sections rather than thirds and never scores them against 33%. Across 1,404 front-facing scans the median upper section is 19.3% of face height, the median middle section 41.1% and the median lower section 39.6%. None of those is near a third. None of them should be, because the ruler starts in a different place.
The useful comparison is to other faces measured the same way. That is what the percentile table below is for.
Live percentiles from our scans
The ranges below come from 1,404 front-facing faces measured with the same definitions. Read your own section against the same column: a lower section at the 75th percentile is longer than three quarters of measured faces, which is information. A lower section that is not 33% is not.
| Section | 5th | 25th | Median | 75th | 95th |
|---|---|---|---|---|---|
| Upper (top of tracked face to mid-brow) | 15.0% | 17.8% | 19.3% | 20.9% | 22.8% |
| Middle (mid-brow to nose base) | 37.3% | 39.6% | 41.1% | 42.8% | 45.6% |
| Lower (nose base to chin) | 33.6% | 37.2% | 39.6% | 41.8% | 45.4% |
What a long or short section usually means
A section that sits toward the edge of the table is a description, not a verdict. Here is what each edge tends to be made of.
Long lower section
Either a long philtrum, a tall chin or both. The chin-to-philtrum ratio separates them. A long lower section with a short philtrum is a strong chin. A long lower section with a long philtrum reads older and is one of the markers that lengthens with age.
Short lower section
A short chin, a short philtrum or a mandible that sits back. Reads younger in most faces. Often paired with a lower face that looks soft in photos, which is a posture and body-fat read rather than a length read.
Long middle section
Usually a long nose or a tall midface between the eyes and the mouth. Interacts with the midface ratio and with how the eyes sit relative to the cheekbones.
Long upper section
In a tracked photo this is mostly about where the hair sits that day. A high hairline, a receding hairline or hair pulled back all lengthen it. It is the section to read with the most caution.
What changes the read without changing bone
The three landmarks that define the sections are bone-anchored except the top one, so most of the levers act on the top band or on the camera.
A fringe or a lower hairstyle shortens the upper section. Hair pulled back lengthens it. A beard that stops at the chin edge keeps the lower section honest while a beard that extends below the chin lengthens it visually. Camera height moves all three: a lens below eye level foreshortens the forehead and lengthens the lower face, a lens above does the reverse. Head pitch does the same thing for free, which is why the same photo setup each time is the only way to compare.
Frequently asked
What are the facial thirds?
The classical division of the face into three vertical bands: hairline to the brow line (upper), brow line to the base of the nose (middle) and base of the nose to the bottom of the chin (lower). The old artistic canon treats them as equal. Measured faces rarely are. The hairline landmark that defines the top band is the least stable point on the face.
Should each facial third be exactly 33%?
No. The equal-thirds rule is a drawing convention, not a measurement of real faces. Lower thirds are commonly a little longer than middle thirds and the upper third depends entirely on where the hairline sits, which moves with age, hair loss and styling. Treat 33% as a reference from art class, not a target your face failed.
Why are LooksMeter's vertical sections not thirds?
Because the tracked face area starts at the top of the detected face, which is at or just under the hairline, not at the trichion of a classical drawing. That makes the upper section smaller than a textbook upper third by construction. Across 1,404 scans the median upper section is 19.3% of face height, the median middle section 41.1% and the median lower section 39.6%. Comparing those to 33% would be comparing two different rulers.
What is a long lower third?
The lower section is the distance from the base of the nose to the chin as a share of face height. In our scans the middle half of faces sits between 37.2% and 41.8%, with the 90th percentile at 44.0%. A lower section above that reads as a longer lower face. Whether that is a long chin, a long philtrum or both is a separate question the lip and chin measurements answer.
Can facial thirds be changed?
The bone cannot, in an adult. The read can. The upper section depends on hairline position, so hairstyle and fringe change it more than anything else. The lower section reads shorter with a beard that ends at the chin edge rather than below it. Camera height shifts all three: a lens below eye level lengthens the lower third, a lens above it lengthens the forehead.
How do I measure my facial thirds at home?
Front-facing photo at eye level, 1.5 metres away, neutral expression, hair off the forehead. Mark the hairline, the point between the brows, the base of the nose and the bottom of the chin, then measure the three gaps as a share of the total. Use the same photo setup every time: a few degrees of head pitch moves the lower third by more than the difference between most people.
Email me the cheat-sheet
Get the cheat-sheet + a first-time member perk
Get our facial harmony & styling reference sheet emailed to you.
Explore more
Keep reading
This page is general information about facial aesthetics terminology, not medical or cosmetic advice. Scores from our tools are calibrated reads of one photo that describe presentation, never your worth.