FREE UTILITY · PRINTABLE PD RULER

Printable pupillary distance ruler in millimetres.

Print this page at 100 percent scale, lay a bank card on the calibration bar to confirm the size, then measure your PD in a mirror. The ruler is drawn in real millimetre units, so no app or scaling step is needed. If you would rather not print, the photo PD tool measures from a selfie.

Full guide: how to measure PD

1 · Calibration check

85.6 mm: the long edge of any bank card, debit card or driving licence should match this bar exactly.

2 · PD ruler, 0 to 80 mm (cut along the top edge)

0
10
20
30
40
50
60
70
80
mm

How to read your PD

  1. Stand about 20 cm from a mirror. Rest the ruler flat against your brow line, numbers facing the mirror.
  2. Close your right eye. Align the 0 mark with the centre of your left pupil.
  3. Keep the ruler still. Open the right eye, close the left eye, read the mark at the centre of your right pupil.
  4. That number is your far PD. Repeat two or three times and keep the value that recurs. Near PD is about 3 mm less.

Adults usually measure 54 to 74 mm. A result outside that range normally means the print was scaled: recheck the card bar.

Calibration note

Printers add their own scaling when fit to page, shrink to fit or borderless options are on. Switch them off and choose 100 percent or actual size. After printing, the long edge of a standard bank card (85.6 mm) must line up with the calibration bar. If the bar is short or long, every millimetre on the ruler is off by the same proportion, so reprint rather than correcting by hand.

On screen the ruler is only accurate if your display reports its true pixel density to the browser, which many laptops and phones do not. Use the printed version or the photo tool for a measurement you intend to order glasses with. For progressive or high powered lenses use the PD on your prescription or ask the dispensing optician.

FAQ

How do I print the PD ruler at the correct size?

Print at 100 percent scale with any fit to page or shrink to fit option switched off. Then lay a bank card along the calibration bar: the card's long edge should match the 85.6 mm bar exactly. If the bar reads short or long, the printer scaled the page and the ruler will be off by the same factor.

How do I measure PD with a printed ruler?

Stand about 20 cm from a mirror, rest the ruler flat against your brow line and close your right eye. Line the zero mark up with the centre of your left pupil. Keeping the ruler still, open the right eye, close the left and read the millimetre mark at the centre of the right pupil. That number is your far PD. Repeat two or three times and use the value that comes up most.