LOOKSMETER · GUIDE
Scleral show and orbital vector, explained
Scleral show is white visible between the iris and the lower lid in a relaxed, level gaze. It is measured in millimetres, named at 1 mm and usually explained by the orbital vector: whether the cheek sits in front of the eye or behind it. Here is how both are measured, how common they are, what causes them and how to read your own. Measure your eye area free →
What scleral show is
In a relaxed, level gaze the upper eyelid covers the top 1 to 2 mm of the iris and the lower eyelid rests at the bottom edge of the iris, give or take a millimetre. White is visible only on either side. Scleral show is the term for white appearing on a third side as well.
Inferior scleral show is white between the lower lid and the iris. It is the common form and the one most people mean. Superior scleral show, white above the iris, is unusual in a relaxed adult face and more often signals upper lid retraction than ordinary variation.
The trait sits at the centre of a cluster of searches: sanpaku eyes, prey eyes, lower lid show, tired eyes. All describe the same anatomy from different angles. The useful move is to measure it.
How it is measured
Lid position is measured from the corneal light reflex, the small reflection at the centre of the pupil when a light is held at eye level. The distance from that reflex up to the upper lid margin is MRD1, typically 4 to 5 mm in adults. The distance down to the lower lid margin is MRD2, typically 5 to 5.5 mm. The iris is about 11 to 12 mm tall, so a lower lid at the iris edge sits just under 6 mm below the reflex.
When MRD2 rises above roughly 5.5 to 6 mm, white appears under the iris. Clinicians record the height of that white band directly. One millimetre is the usual threshold at which it is called show. Two millimetres or more is marked. Many also note whether the band is wider at the outer corner, which points to lateral lid laxity. An even band across the eye points to globe prominence instead.
From a photo the iris works as a ruler. One tenth of its height is about 1 mm. Measure in an eye-level, straight-gaze image only, since looking up by a few degrees adds a millimetre of apparent show in anyone.
| Measure | Typical adult | Show threshold |
|---|---|---|
| MRD2, pupil centre to lower lid | 5 to 5.5 mm | About 6 mm or more |
| Inferior scleral show | 0 mm | 1 mm or more |
| Marked scleral show | 2 mm or more | |
| Iris vertical height (ruler) | 11 to 12 mm | One tenth is about 1 mm |
The orbital vector
Scleral show rarely exists on its own. It is usually the surface sign of how the eye sits relative to the bone beneath it, which is what the orbital vector describes.
On a side view, drop a vertical line from the most forward point of the cornea. If the highest point of the cheekbone and the skin of the lower lid sit in front of that line, the vector is positive. The lower lid has a shelf to rest on, stays at the iris edge and the lid-cheek junction is smooth. If the cheek sits behind the line, so that the eye projects beyond it, the vector is negative. The lid has no support, tends to drift down, exposes white and the groove between lid and cheek deepens into a visible tear trough. When the two line up the vector is neutral.
Jelks and Jelks introduced the term in 1991 to flag patients whose lower lids were likely to sit low after surgery. It has since become the standard way to explain why two people with the same lid tone can show very different amounts of white: one has a cheek under the eye and the other does not.
A negative vector comes from one of two places. Either the cheekbone is flat or recessed, which is skeletal and often runs in families. Or the eye itself is prominent, which can be skeletal too or can come from a long eyeball in high myopia or from conditions that push the globe forward.
How common each pattern is
Lid position studies describe a modest sex difference: men on average carry a lower resting lower lid by a fraction of a millimetre, so marginally more show for the same globe position. Deep-set eyes, which sit behind a strong brow and cheek, almost never show white. Prominent eyes do so readily. Orbital shapes with a lower, rounder lower lid and forward cheek support, common in East Asian and many South Asian faces, tend toward less inferior show and a more positive vector.
Age is the dominant factor. The small tendons holding the lower lid at its corners lengthen through the fifties and sixties, so MRD2 rises and show becomes ordinary in older faces. Young adults with 1 mm or more of show at rest are the minority and almost always have a negative or neutral vector explaining it.
The surrounding eye geometry decides how visible it is. Across 1,404 front-facing scans the median canthal tilt is +4.2° and 91.2% of faces have a positive tilt. A positive tilt lifts the outer corner and lets the lower lid cross the iris on a slope, which hides a small amount of white. A flat or negative tilt, below the 10th percentile at +0.3°, shows the same amount of white more plainly.
What creates it
Five causes, from most to least common in a young adult.
Gaze and camera position
Looking up a few degrees, chin down with eyes raised or a lens held above eye level exposes white beneath the iris in anyone. This explains the majority of show that people notice in photos and none of the show that exists at rest.
Negative orbital vector
Flat cheekbone or prominent globe. Skeletal, present from the late teens, stable through adulthood. The lid has nothing to rest on and sits low.
Lower lid laxity
Stretched lateral and medial tendons from age, chronic rubbing, allergy or contact lens handling. The lid sags most at the outer corner, so the white band is wider laterally. The usual cause of show that appears in midlife.
Previous lid procedures or trauma
Scarring on the inner surface or skin shortage on the outer surface of the lower lid pulls it down. Show that appeared after a procedure belongs with the clinician who performed it.
Lid retraction from medical causes
Thyroid eye disease and a few other conditions pull the lids back or push the globe forward. New show, show in one eye, a staring look, grittiness or double vision are reasons to see a clinician rather than measure at home.
How to check your own eyes
Front view first. Camera at exact eye level, a step beyond arm's length, flat daylight, neutral face, gaze straight into the lens. Zoom in on one eye. If the lower lid touches the bottom of the iris there is no show. If white separates them, compare the band to the iris height: one tenth is 1 mm. Repeat for the other eye. An asymmetry over 1 mm is more telling than the absolute figure.
Then the side view. Camera at eye level, head in profile, hair off the temple. Drop a vertical from the front of the cornea. If the cheek skin below the eye sits in front of that line the vector is positive, if level it is neutral, if behind it is negative. Pair the two reads: show plus negative vector is structural, show plus positive vector is more likely lid tone or gaze, no show plus negative vector is a lid doing extra work and worth keeping an eye on as you age.
The free Hunter Eye Test reads canthal tilt, lid exposure and eye outline from the front view on your device. The Side Profile Analyzer gives the cheek and eye projection that decide the vector. Together they replace a guess with two numbers.
Frequently asked
What is scleral show?
Scleral show is visible white between the edge of the iris and the eyelid margin when the eye is relaxed and looking straight ahead at eye level. Inferior scleral show, white below the iris, is the common form. Superior scleral show, white above, is rarer at rest. Clinicians record it in millimetres from the lid margin to the iris edge. Below 1 mm it is treated as ordinary variation in lid position. At 1 mm or more it is named as show. The same trait is what the term sanpaku describes in popular usage.
What is a negative orbital vector?
Stand side-on and imagine a vertical line dropped from the front of the cornea. If the cheekbone and lower lid skin sit in front of that line, the orbital vector is positive. If they sit behind it, so the eye projects beyond the cheek, the vector is negative. The term comes from Jelks and Jelks in 1991 and is used to predict how the lower lid behaves, since a lid with no cheek support beneath it tends to sit lower, show more white and form a deeper tear trough. Neutral is when the two line up.
Is scleral show normal?
A trace of it is. Lower lid position varies by a millimetre or two across healthy adults, so some faces show a sliver of white in neutral gaze without anything being wrong. Persistent show of 1 mm or more is less common in young adults and usually reflects orbital shape: a prominent eye, a flat cheekbone or both. In later life it becomes common as the lower lid loosens. Show that is new, increasing, asymmetric or accompanied by bulging, dryness or double vision is the version to raise with a clinician.
Does scleral show make eyes look tired?
It tends to. The lower lid resting at the iris edge gives the eye an almond outline that observers read as calm. White beneath the iris rounds the lower half of the eye and matches the position of someone startled or looking upward, which reads as alert, strained or tired depending on the rest of the face. Combined with a flat or negative canthal tilt the look is what online guides call prey eyes. Combined with a positive tilt and a low brow it is far less noticeable.
Can scleral show be fixed?
Depends on the cause. Show created by camera height, gaze direction or head tilt disappears when those change, which covers most of what people see in selfies. Structural show from a negative vector or lax lid does not change with sleep, skincare or exercises. Procedures exist that support the cheek, tighten the lower lid or reposition it. This page does not recommend any of them. If the show is structural and bothers you, a consultation with an oculoplastic clinician is the appropriate next step, not a product.
Email me the cheat-sheet
Get the cheat-sheet + a first-time member perk
Get our facial harmony & styling reference sheet emailed to you.
Explore more
Keep reading
Upper eyelid exposure
Crease height, pretarsal show and why hunter eyes show less lid, with the hooded, deep-set and ptosis patterns told apart.
Epicanthic fold
The inner-corner fold: four types, who has one, how it differs from a monolid and how it shifts eye readings.
Red light therapy for the face
What controlled LED trials show for wrinkles, texture and acne, the doses used, effect sizes and limits.
This page is general information about facial aesthetics terminology, not medical or cosmetic advice. Scores from our tools are calibrated reads of one photo that describe presentation, never your worth.